Processing plastic releases a lot of heat, gases, vapors and dust. These conditions have a negative effect on the comfort and well-being of your employees. Therefore, cooling and optimal ventilation are fundamental to your business. IntrCooll cools your factory with fresh, filtered outside air. The steady flow of ventilation refreshes inside air completely, several times an hour.
Only the best for your employees
IntrCooll delivers air with a low temperature and good relative humidity. Fresh, cool air creates comfort and well-being for your valuable employees. The pleasant working climate results in increased productivity and higher output.
Unique two-stage cooling
IntrCooll uses two-stage indirect / direct adiabatic cooling. This natural cooling process cools fresh air using cold recirculation water, without water evaporation. The chilled air is cooled even further by direct evaporation with the patented Oxyvap® at this final step. Unlike other adiabatic cooling systems, humidity levels remain low and chances of condensation on cooled molds are minimized.
Oxycom provides your factory with the perfect climate, even in winter and spring. IntrCooll's Heat Reclaim module reuses indoor heat to warm up fresh outdoor air.
IntrCooll is the perfect fit for all activities within the plastics industry:
- Injection molding
- Profile extrusion
- Film extrusion
- Vacuum forming
- Blow molding
- Rotational molding